Do you own room that might use a ceiling fan Its not hard to install a ceiling fan by yourself if you are preparing to replace a light fixture. Because a ceiling fan needs the same cabling as your light fixture, the only major thing that needs to be done is to transfer the workbox that can handle the weight of the ceiling fan. Hanging your brand new ceiling fan on an existing box that won't support the extra weight of the fan could end up in disaster. Just before you do anything, read the guidelines for your fan very cautiously and make certain you have the essential tools.

woodworking plans When you find yourself hanging the fan over a cathedral ceiling, you may require to purchase additional parts for extending the fan straight down lower. When you have everything ready to go, the very first thing you should do is make sure that the breaker is turned off so no power goes to the light fixture. When you take out the light fixture, examine to see if the pre-existing workbox can handle the extra weight. In many cases, the workbox will not be able to hold the extra weight so you may need even more support. Including support to the workbox is not that difficult if you have admittance to the light fixture from the attic.

To extra support, you nail a 2x4 inside the ceiling rafters where it meets the top of the workbox. Ensure the 2x4 is secured in its place, and then bolt the box to the wood. If everything is carried out the right way, the weight of the fan will now be totally supported by the wood and the screws. If you are incapable to do it from the attic room or you have basically no attic, you will have to create a cross bracing in your ceiling. Carrying out this is much more of a challenge and may not be as secure as using a 2x4 but it is the best you can do if you dont get access to the attic.

At this point, after assembling the fan as stated by the instructions, you are prepared to put any fan. The tough part is linking the wiring while retaining the fan. The difficulty is based on the type of fan you acquire, whether it is a draping frame or a fan that has a bracket with a J hook. good woodworking ideas For many fans the wall switch will turn it on or off, and the chain will control the speeds. If you need a light kit together with your fan, they can be controlled by either chain or wall switch.

Electrical wiring the fan is simply by connecting two black wires, two ground wires and two white wires woodworking plans. Once you have accomplished the wiring, all you need to do now is affix the blades. Right after you attach the blades, the only thing left is to turn the breaker back on to find out if you did it right.